Abstract
The formation of the first membrane, the swelling of the crystal by incoming water from the semipermeable membrane and the formation of irregular shaped branches were observed by optical microscopy, when zinc sulfate heptahydrate crystals were immersed in saturated borax solution. The powders obtained by mixing dilute aqueous borax and zinc sulfate solutions had B, O, Na, S and Zn elements. Presence of Na Zn 1/2B4O7.xH2O was indicated by EDX analysis. The molar ratio of B 2O3/ZnO in powders was around 2. FTIR analysis indicated the ratio of absorbance values of asymmetric stretching vibrations of B(3)-O at 1351 cm-1 to that of B (4)-O at 1026 cm-1 increased with their heating time at 90ºC during their preparation. X-ray diffraction patterns indicated the presence of Zn(OH)2 and Zn 4(OH)6(SO4)·4H2O. The zinc borate compounds in the powders were not crystalline since no sharp peaks related to zinc borates were present in x-ray diffraction diagram. There were two mass loss steps in TG curves of the powders. The first step at 150-350ºC and the second step at 700-950ºC were due to elimination of water and due to decomposition of sulfate ions respectively. The submicron powders were a mixture of zinc borate, Zn(OH)2, Zn4(OH)6(SO4)·4H2O and Na Zn 1/2B4O7.xH2O and they could be used as lubricant additive due to their small particle size of 600 nm.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.