Abstract
Time division multiplier was widely used in high-precision industrial frequency AC power measurements.The poor stability of zero point was caused by the switch leakage and amplifier offset voltage. Based on the experimental study of the time division multiplier circuit designed in the article, the mathematical model of zero point compensation was established, and then the appropriate calibration method was proposed. Considered the amplifier offset voltage, the error model of the time division multiplier was analyzed and the error expression was obtained. These can provide theoretical guidance for choosing amplifiers of the no-beat time division multiplier.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.