Abstract
The inner characteristics of solidification and crack propagation in laser spot welding of four representative aluminum alloys, A1050, A2024, A5083 and A6061, were firstly observed with the X-ray phase contrast method. Keyhole disappeared within 1 ms after the laser was shut down. The solidification process finished in 2 ms for A1050, 3 ms for A2024, 5 ms for A5083, and 3 ms for A6061, respectively. Longitudinal view area of the molten pool decreased as the thermal conductivity increased, while the average solidification rate increased with increase of the thermal conductivity. Hot crack was observed to propagate from the bottom to the upper surface in the center of spot weld of A2024, A5083, and A6061, which was also the first in situ observation of crack during the welding process. Both the SEM, EBSD and Micro-X-ray computed tomography (CT) results validated that there was a crack propagation in the spot weld, and the mechanism for this crack formation was discussed. This paper provides a better understanding of solidification and crack formation in laser manufacturing.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
