Abstract
A low-cost system able to perform microtomography of samples such as teeth, insects, or other small materials and low atomic numbers is presented. For this, a small flat panel type sensor was used. The process of characterization of the detector is detailed, as well as its main characteristics. The electromechanical control and the software used are also described. The advantages, some limitations, and comparisons with commercial systems are presented along with some three-dimensional volumetric reconstruction of different materials that served as samples during the development of the system.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.