Abstract
The wrinkling behavior of the ultra-thin components during the tube hydro-pressing process was investigated by finite element analysis and confirmed by hydro-pressing experiment and the causes of various typical defects were explored. There are three typical wrinkle defects appearing on the part during the tube hydro-pressing process: transverse wrinkles, longitudinal wrinkles and oblique wrinkles. The transverse wrinkles are mainly caused by compressive stress perpendicular to wrinkles. The longitudinal wrinkles are mainly caused by tensile stress parallel to wrinkles. While, the oblique wrinkles are mainly due to shear stress.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IOP Conference Series: Materials Science and Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
