Abstract

Summary form only given. We have developed and present here a prototype point-to-point wireless video system that has been implemented using a combination of commercial components and custom hardware. The coding algorithm being used consists of subband decomposition using low-complexity, integer-coefficient filters, scalar quantization, and run-length and entropy coding. The prototype system consists of the following major components: spread spectrum radio with interface card and driver, compression board, and an NEC laptop and docking station which provide the PC bus slots and control. The compression algorithms are implemented on a board with a single 10000-gate FPGA. Prior to implementing the algorithms in hardware, a study was performed to resolve issues of word length and scaling, and to select quantization and run length parameters. It was determined that 16-bit precision in the wavelet transform stage is sufficient to prevent under-low and overflow provided that rescaling of data is correctly performed. After processing by the FPGA, the compressed video is transferred to the PC for transmission over the radio. A commercial serial card (PI Card) provides a synchronous serial interface to the radio. The serial controller chip used by this card supports several serial protocols and thus the effect of the these protocols on the data in a wireless environment can be tested.

Full Text

Published Version

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.