Abstract
Wire sweep has been recognized as a critical process defect which can result in device failure. The phenomenon is very complicated as it is sensitive to a large number of parameters. In this experimental work, the influence of some of the more important factors is investigated. These parameters include fluid-flow speed, wire-bond density, mold cavity height, and mold vent size. A 160L QFP package bonded with gold wires in a transparent mold is used as the test vehicle.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
