Abstract
The addition of conducting particles in the ceramic matrix material increases the overall electrical conductivity of the composite. Current work is an approach to machine multi walled carbon nanotubes filled alumina composites by wire electrical discharge machining process. The variation of material removal rate and surface roughness are identified for varying conditions of pulse on time. An increasing material removal phenomenon is observed with increase in pulse on time. The surface roughness is found to decrease under similar conditions. The effect of wire speed is also thoroughly analyzed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.