Why only half of the added ansa-metallocene catalyst active in the E/P/diene polymerization: catalyst evaluation in terms of active center [Zr]/[C*] fraction and polymerization propagation rate constants

Abstract

To understand how the silyl-bridged metallocene catalysts rac-Me2Si(2-Me-4-Ph-Ind)2ZrCl2 behave against dienes under the same reaction condition because of its importance as a commercial polymerization catalyst and ethylene propylene diene monomers (EPDM). Adding diene depressed the catalytic activity, especially 5-ethylidene-2-norbornene (ENB) exerted the most substantial deactivation effect. Firstly, we examine the (ENB, vinyl norbornene (VNB) and 4-vinylcyclohexene (VCH)) non-conjugated and conjugated (isoprene (IP), butadiene (BD)) diene and address how polymerization catalysts behave against these dienes. For example, the catalytic activity was enhanced with IP and BD (3–3.3106 gm/mmolMt·h) compared to ENB, VNB and VCH. The VNB incorporation rate was prolonged (5.4 mol%), but with IP and BD, it was relatively moderate. E/P/IP and E/P/BD with higher incorporation of E produced a higher MW, which means that the chain transfer reaction with ethylene is slower than P. Secondly, we address how the dienes exocyclic and exocyclicπ bonds of non-conjugated and conjugated properties of IP and BD affect the kinetic measurements such as active centers [Zr]/[C*] fraction, EPDM chain propagation, termination, and isomerization. Finally, we compare [Zr]/[C*] and kpPE, kpP and kpDienes for different EPDM. After collecting these kinetic parameters, we can describe the mechanism’s intricacy and the existence of considerable catalyst dormancy with dienes under identical reaction conditions.