Abstract

Direct measurement and control of the dynamic wetting properties of a lipid-coated water-air interface over a wide range of surface tension variations have many important applications. However, the wetting dynamics of the interface near its partial-to-complete wetting transition has not been fully understood. Here, we report a systematic study of the wetting dynamics of a lipid-coated water-air interface around a thin glass fiber of diameter 1-5 μm and length 100-300 μm. The glass fiber is glued onto the front end of a rectangular cantilever to form a "long-needle" atomic-force-microscope probe. Three surface modifications are applied to the glass fiber to change its wetting properties from hydrophilic to hydrophobic. A monolayer of phospholipid dipalmitoylphosphatidylcholine (DPPC) is deposited on the water-air interface in a homemade Langmuir-Blodgett trough, and the surface tension γL of the DPPC-coated water-air interface is varied in the range of 2.5 ≲ γL ≲ 72 mN/m. From the measured hysteresis loop of the capillary force for the three coated fiber surfaces with varying γL, we observe a sharp transition from partial to complete wetting when γL is reduced to a critical value (γL)c. The obtained values of (γL)c are 27 ± 1 mN/m for a DPPC-coated fiber surface and 23 ± 1 mN/m for an trichloro(1H,1H,2H,2H-perfluorooctyl) silane (FTS)-coated surface. Below (γL)c, the contact angle θ0 of the liquid interface is found to be zero for both hydrophobic fiber surfaces and the corresponding spreading parameter S becomes positive. For the FTS-coated fiber surface, the height of capillary rise exhibits a jump when γL is reduced to (γL)c, which indicates that a rapidly advancing liquid film is formed on the fiber surface when the partial-to-complete wetting transition takes place. Our experiment thus establishes a quantitative method by which many other liquid interfaces coated with polymers, surfactants, and biomolecules (such as proteins and lipids) may be characterized dynamically.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call