Abstract
Friction stir spot welding has been shown to be a viable method of joining ultra high strength steel (UHSS), both in terms of joint strength and process cycle time. However, the cost of tooling must be reasonable in order for this method to be adopted as an industrial process. Several tooling materials have been evaluated in prior studies, including silicon nitride and polycrystalline cubic boron nitride (PCBN). Recently a new tool alloy has been developed, where a blend of PCBN and tungsten rhenium (W-Re) was used in order to improve the toughness of the tool. Wear testing results are presented for two of these alloys: one with a composition of 60% PCBN and 40% W-Re (designated as Q60), and one with 70% PCBN and 30% W-Re (designated at Q70). The sheet material used for all wear testing was DP 980. Tool profiles were measured periodically during the testing process in order to show the progression of wear as a function of the number of spots produced. Lap shear testing was done each time a tool profile was taken in order to show the relationship between tool wear and joint strength. For the welding parameters chosen for this study the Q70more » tool provided the best combination of wear resistance and joint strength.« less
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
