Abstract
Hydraulic turbines are usually operating at high efficiencies around 90%. It is possible to increase the efficiency by preventing flow characteristics such as failure, cavitation and vortex rope in the draft tube. In some cases, such as partial loads or overloads, pressure pulsations and vortex rope would occur in the draft tube. These undesired events would damage the components of the turbine and that also causes the efficiency to decrease. To eliminate these artifacts, it is decided to design a new component. Vortex Preventing Element, which is designed to eliminate vortex structures and pressure fluctuations, is located at the inlet of draft tube. Computational Fluid Dynamics analyses are performed for different designs having several stage numbers of vortex preventing elements. The preliminary results showed that the one stage vortex preventing element design creates more uniform flow in the draft tube and also increases the efficiency about 3%. Since more studies about the vortex preventing element are in progress, it could be said that the vortex preventing element can handle vortex phenomena in the draft tube and effects the efficiency of the Francis turbines.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.