Abstract
Vibration and noise reduction of an optical disk drive by using a vibration absorber is presented in this paper. In optical disk drives such as CD-ROM or DVD drives, vibration may become one of serious problems to be resolved as the rotating speed and the storage capacity increase. It is practically difficult to overcome the off-track and off-focusing errors by only the servo control without reducing vibration. In particular, when an optical disk drive has a wavy spinning disk, it may suffer from severe vibration. Based on the vibration signals measured by a laser vibrometer and an accelerometer, the resonance frequency of the disk drive is identified. For reduction of the vibration around the resonance frequency, a vibration absorber is designed and it is equipped on the feeding deck of the drive. The proposed vibration absorber consists of a steel plate ring and a rubber bobbin, which play roles of inertia mass and a spring, respectively. During the design procedure of the absorber, a finite element model is used to determine the required fundamental natural frequency of the absorber. The test results of vibration and noise after being equipped with the absorber show that vibration and noise of the optical disk drive are considerably reduced.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call