Abstract

Power semiconductor devices require low on-resistivity and high breakdown voltages simultaneously. Vertical-type metal-oxide-semiconductor field-effect transistors (MOSFETs) meet these requirements, but have been incompleteness in diamond. Here we show vertical-type p-channel diamond MOSFETs with trench structures and drain current densities equivalent to those of n-channel wide bandgap devices for complementary inverters. We use two-dimensional hole gases induced by atomic layer deposited Al2O3 for the channel and drift layers, irrespective of their crystal orientations. The source and gate are on the planar surface, the drift layer is mainly on the sidewall and the drain is the p+ substrate. The maximum drain current density exceeds 200 mA mm−1 at a 12 µm source-drain distance. On/off ratios of over eight orders of magnitude are demonstrated and the drain current reaches the lower measurement limit in the off-state at room temperature using a nitrogen-doped n-type blocking layer formed using ion implantation and epitaxial growth.

Highlights

  • For the vertical device with the N-doped epitaxial layer, we used n-type diamond covered with a boron-doped layer

  • An additional n-type diamond layer was fabricated by 1.7 MeV hot implantation of nitrogen ions

  • From Stopping and Range of Ions in Matter (SRIM) simulations, a nitrogen-doped n-type diamond layer was fabricated at a depth of approximately 1 μm from the substrate surface and the nitrogen concentration was ~1019 cm−3

Read more

Summary

Introduction

For device with N-implanted layer, we deposited a 2.0-μm-thick undoped epitaxial layer to develop a drift layer by microwave plasma chemical vapor deposition (MPCVD) on the p+-type diamond substrate. The growth temperature, time and chamber pressure for the undoped epitaxial layer were 600 °C, 15 h 20 min and 35 Torr, respectively. An additional n-type diamond layer was fabricated by 1.7 MeV hot implantation of nitrogen ions.

Results
Conclusion

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.