Abstract
Designing a vehicle involves testing the vehicle under realistic simulations and scenarios to see how the vehicle responds. Manually performing all these tests would be expensive and there is also the risk of human life. In this paper, a vehicle driver model is modeled which can be used as a substitute for real drivers in simulations. The motion of the vehicle is considered in two components, longitudinal component, and lateral component. Both these components are implemented using controllers. The model was built using MATLAB Simulink software and using path designer application, different paths were designed and the model was tested on them. The steering angle, velocity, acceleration, deceleration values generated for two test cases are displayed. The path followed by the driver model was also observed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Journal of University of Shanghai for Science and Technology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
