Vat photopolymerization for thermal energy storage applications using encapsulated phase change material suspended in photocurable resin

Abstract

Listen

Translate article

A novel approach to additively manufacture latent heat thermal energy storage heat exchangers through the development of microencapsulated phase change material (MEPCM) suspensions in photocurable resin for vat photopolymerization (VPP) 3D printing is presented. Using MEPCM addresses the leakage risks that have typically been associated with PCMs and subsequently makes the particulates a suitable additive for VPP 3D printing. In the current study, VPP was employed to fabricate functional composites with varying MEPCM mass fractions for thermal, rheological, microstructure, and chemical characterization. Microstructure visualization was conducted to assess the overall distribution of MEPCM within the 3D printed samples and to confirm the structural integrity of the encapsulated particles after printing. The influence of the base resin viscosity was explored by investigating two photocurable resins with different viscosities—a high-tensile UV photopolymer and an ABS-like resin—during the printing process. Thermal properties, such as latent heat of fusion, phase-change temperature, thermal conductivity, and decomposition temperature of the 3D printed samples were determined. Rheology was used to observe the effect of varying shear rates on the MEPCM-resin mixtures to identify the optimal viscoelastic properties for VPP 3D printing. It was determined that the ABS-like resin was able to contain a larger amount of PCM (40 wt%) while maintaining printability due to the lower viscosity of the corresponding pure resin. The 40 wt% MEPCM composite exhibited an average viscosity of 18,817 cPs, a maximum latent heat of fusion of 54.12 kJ/kg, and a 12.4% reduction in thermal conductivity compared to the pure polymer.