Abstract

The heartwood percentage and wood colour of fast plantation grown teak destined for harvest at 5 years of age were characterized using automatic image processing ’ImageJ’ routines and CieLab’s colour system with the following coefficients: L for lightness, a* for redness and b* for yellowness. Analyses were conducted on material from different dry and wet sites. Comparison with 6-year old plantation from a dry site was conducted to study differences arising in older trees. Analyses of variation of those properties between and within different tree diameter classes were also conducted. The results showed that brightness, redness and yellowness values of 5-year old teak trees were 60.7, 10.7 and 23.1, respectively. Tree clone had a more dominant effect on wood colour and heartwood proportion than site, thus if specific colour preferences are needed of plantation trees, clone selection is important. The drier site produced larger proportions of heartwood in trees, as well as a more attractive figure. The trees produced heartwood proportions of 20% and 14% from the dry and wet sites respectively. On average, these 5 year old teak trees already produced 18% heartwood. Faster tree growth (larger diameter) appeared to have produced significantly larger heartwood proportions. Radially, the palest colour (the highest L but the lowest a*b* parameters) occurred in an area between heartwood and sapwood indicating the presence of a transition zone in all the tree samples.

Highlights

  • In Indonesia, there has been an effort to cultivate fast grown plantation teak with the aim to harvest it within 5 years-‘super teak’

  • Tests were further conducted to analyse the difference between 5- and 6-year-old Jati Utama Nasional (JUN) teak trees (Table 3)

  • As the 6-year-old teak was only available from the dry site, the comparison was carried out between 5- and 6-year-old teak trees at this site

Read more

Summary

Introduction

In Indonesia, there has been an effort to cultivate fast grown plantation teak with the aim to harvest it within 5 years-‘super teak’. While intensive timber production may induce changes to the anatomical and technical properties of the wood colour, density, durability, and mechanical properties, potentially this may affect the suitability of using such timber for high quality products (Saranpaa 2003). To test this assertion, an investigation was undertaken of the wood properties to determine the possible utilization potential of the very fast grown teak. Teak is highly regarded for its wood colour and this is considered as an important aspect for its marketing (Nocetti et al 2011). It is the attractive figure that is one of the major reasons why this species is widely planted commercially (Moya and Marin 2011)

Objectives
Methods
Results
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call