Abstract
Abstract. East Asia is suffering from severe air pollution problems due to intensive anthropogenic emissions and natural mineral dust aerosols. During transport, the aerosol particles undergo complex mixing processes, resulting in great impacts on regional air quality, human health and climate. In this study, we conducted a long-term observation using an optical particle counter equipped with a polarization detection module (POPC) at an urban site in Beijing. Mass concentrations of both PM2.5 and PM10 estimated from POPC compared well with ground-based measurements. The results revealed that the observed depolarization ratio (δ, termed as the ratio of the intensity of the s-polarized signal to the intensity of the 120∘ backward scattering signal [s/(s+p)]) for aerosol particles in the fine mode was generally much lower in summer than that in spring as a result of predominance of different aerosol types. Mineral dust particles in the coarse mode normally had a large δ value (0.3±0.05) owing to their nonspherical shape; however, particles in the fine mode mostly had water-soluble compositions, which led to an apparent decrease of their δ values in particular high relative humidity (RH) conditions. Because the observation site was subject to the impact of frequent dust events in spring, the δ value of particle at 1 µm was almost twice as high as that (0.07±0.01) in summer. Based on size-resolved δ values, anthropogenic pollutants, mineral dust and polluted mineral dust particles and their contribution to local air quality could be well distinguished. About 26.7 % of substandard days (daily averaged PM2.5 concentration larger than 75 µg m−3) in Beijing featured high atmospheric loading of coarse-mode particles in winter and springtime. In particular, during severe pollution episodes in winter, the δ values of coarse-mode particles decreased by 13 %, which implies a high possibility of dust-related heterogeneous processes in pollution formation. During dust events, δ values of particles with optical size (Dp) of 5 µm evidently decreased, with an increase of the PM2.5 ∕ PM10 ratio as well as RH, indicating the morphological changes of mineral dust. This study confirmed that high RH tends to promote water absorption processes on the dust surface as well as the coating of soluble compounds, and suggested that remote sensing techniques for aerosols may underestimate the impact of dust particles due to the complex mixing of dust and anthropogenic particles in urban areas, and the interaction between dust particles and pollutants should be considered well by the optical model.
Highlights
Rapid economic growth and urbanization processes in East Asia have caused serious air pollution in the past decades owing to the substantial consumption of fossil fuel
There is observational evidence that heavy dust mixed with anthropogenic pollution may trigger new particle formation (Dupart et al, 2012; Nie et al, 2014), which exaggerates the degradation of regional air quality
The averaged δ value of particles in both fine and coarse mode was highest in March 2016 (0.26) and lowest in July 2016 (0.19)
Summary
Rapid economic growth and urbanization processes in East Asia have caused serious air pollution in the past decades owing to the substantial consumption of fossil fuel. Aerosol types can be distinguished by the distinct parts formed by data points on a figure of their volume depolarization ratio (δa = s/p, at 532 nm) of aerosols versus backscattering color ratio (1064 nm / 532 nm); bias in the classification of internal mixed dust (normally has a large color ratio and small δa) is sometimes unavoidable since external mixing of a substantial amount of fine particles (δa < 0.1) with mineral dust aerosols (δa > 0.35) can result in a decrease of the δa value.
Sign-in/Register to view highlights & summary 
Published Version (
Free)
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call