Validated capillary zone electrophoretic method for simultaneous analysis of benazepril in combination with amlodipine besylate and hydrochlorothiazide

Abstract

In this work, a novel, simple, and quick capillary zone electrophoresis (CZE) method was proposed for simultaneous analysis of benazepril (BEN) with other co-administrated antihypertensive drugs, amlodipine besylate (AML) and hydrochlorothiazide (HCT), using a diode array detector (DAD). A fused silica capillary (78.5 cm total length, 70 cm effective length, and 75 μm id) was used in separation using a 40 mM phosphate buffer pH 7.5 as a running background electrolyte (BGE) under a positive potential of 30 KV, at a stable temperature of 25 °C for capillary during separation. Hydrodynamic injections were performed for 12 s at 50 mbar, and detection was performed at 210 nm for AML and BEN, at 225 nm for HCT, and at 232 nm for xipamide (XIP) added as an internal standard (IS). Separation of the three analyzed drugs and the IS was performed in less than 8 min. Migration times were 4.06, 5.23, 6.69, and 7.3 min for AML, HCT, BEN, and XIP, respectively. The findings proved that the proposed method was linear in the range of 10–80 μg/mL for all drugs with correlation coefficients >0.9994. The limit of detection (LOD) values of AML, HCT, and BEN were 1.004, 1.224, and 0.896 μg/mL, respectively, whereas the limit of quantification (LOQ) values were 3.124, 3.727, and 2.749 μg/mL for the cited drugs, respectively. Peak identity and purity were confirmed by DAD. The developed CZE method was applied for the analysis of the three antihypertensive drugs successfully in their combined pharmaceutical tablets, and it can be used for the quality control of single-pill combination (SPC) samples of these drugs in short time.