Using the Plasma Jet Method to Create Zinc Nanoparticles and Study Their Structural and Optical Properties as an NH3 Gas Sensor

Abstract

In this work, zinc nanoparticles were prepared using the low-temperature plasma method at different times 3 min, 5 min, 7 min, 9 min, where the initial reactions of zinc lead to the formation of nanoparticles. The metal interacts with the ionized plasma under different conditions and may turn into an oxide such as exposing the sample to air and raising the temperature of the solution a few degrees as a result of high voltage and within a certain range. The atmospheric pressure plasma system acts as the cathode, while the zinc metal strip acts as the anode. A series of techniques were used, including the use of X-ray diffraction (XRD), ultraviolet-visible spectroscopy and scanning electron microscopy (FESEM). The X-ray diffraction results showed that the samples have polycrystalline structures with hexagonal and cubic structures with a time difference, and the X-ray diffraction results showed the conversion of zinc particles into zinc oxides. FESEM images reveal particle size and shape. The ZnO nanoparticles prepared by the mentioned method seem to form different nanoshapes such as starfish and mushroom nanoparticles. The UV-visible results showed that the samples had an energy gap of about 3.4 eV at a time of 3 min, and this value decreases with increasing reaction time. The appearance of zinc oxides increases gradually with the passage of time. These results provide credibility for the fabrication of ZnO nanostructures for use in future gas sensing applications, despite the inhomogeneity of particle size among ZnO particles, the sensor was also fabricated to detect nitrogen gas (NH3) with different concentrations (17.25 ppm, 46.38 ppm, 78.58 ppm). at room temperature. The ZnO sample showed the highest sensitivity (88.1%) at 7 min. The sensitivity showed different results and increased with reaction time and gas concentration. However, response and recovery time are moderate and decrease as reaction time increases.