Using gravity gradient component and their combination to interpret the geological structures in the eastern Tianshan Mountains

Abstract

SUMMARY As early as the Palaeozoic era, the Tianshan Mountains constituted a vast tectonic convergent zone within the Eurasian Continent; by this time, they had already experienced multiple intense crustal movements. The Indian Plate is currently advancing northwards by more than 50 mm yr–1; it affects the Tianshan Mountains even though they are located more than 1000 km away. However, many of the geological issues of the Tianshan Mountains, especially in eastern Tianshan, which remains an active tectonic zone today, are not yet fully understood. There have been few studies into the seismogenic characteristics of this intense seismic zone. Here, the full gravity gradient tensor (GGT) within the eastern Tianshan Mountains was calculated using a stable spatial frequency domain algorithm, based on high-spatial resolution (7.2 arcsec or approximately 200 m) Global Gravity Model plus (GGMplus) surface gravity data. In addition, the features of the geological structures in the eastern Tianshan Mountains were interpreted using different combinations of GGT components. Moreover, the possibilities of using different combinations of GGT components to identify the distributions and strikes of faults was discussed regarding the potential earthquake rupture risks in this study area. The results show that (1) the distributions and strikes of the main fault zones in the study area are highly consistent with the linear geological features within the mountains, as extracted from a combination of different GGT components, including terrain effects. (2) Removing the terrain effects revealed that the different components of GGT (derived from the complete Bouguer gravity anomaly) vary gently, showing few linear geological features that could be extracted. This implies that satellite gravity data are not sufficient to analyse the characteristics of small underground geological structures (spatial scales less than ∼10 km). (3) Comparing the spatial distributions of fault traces depicted at different ages with the linear geological features of the study area revealed that discovering more unknown faults increased the coincidence ratio of linear geological features to fault traces in the area (from 27 to 40 per cent). In conclusion, the findings of this study represent a valuable reference for further revealing the seismogenic characteristics of this area, where there is a lack of detailed surface fault structure measurements due to its inaccessibility. The proposed method could also recognize faults in other similar areas with harsh conditions that are not feasible for ground-based surveys, such as forests and glaciers.