Abstract
ABSTRACTAn in‐line slit‐die viscometer (SDV) was used to measure the viscosity of a melt extrudate independently of the extruder operating conditions. The melt produced by extrusion of the corn grits followed a power law rheological model. The viscosity of the melt and extrusion parameters such as specific mechanical energy (SME), torque, and die pressure decreased with increasing moisture content. The degree of starch gelatinization increased when barrel temperature increased from 90 to 130°C. At temperatures higher than 130°C, most of the starch had gelatinized. The increase in barrel temperature, however, resulted in small changes in the apparent viscosity of the melt, until a maximum of ≈130°C. At a constant feed rate, SME increased and torque decreased when screw speed increased due to the shear thinning behavior of the melt. At a constant screw speed, the torque increased and SME decreased with increasing feed rate. This was due to a decrease in apparent viscosity of the melt at higher feed rates. SME is not an independent extrusion variable and should be used with caution either when predicting the effect of thermomechanical treatment of the product or as the key and only variable for controlling the food extrusion process.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have