Abstract

In Europe, the use of wastes in the cement and construction industry follows the assumptions of sustainability and the idea of circular economy. At present, it is observed that cement plants introduce wastes to the cement in the form of so-called mineral additives. The most often used mineral additives are: fly ash with silica fume, granulated blast furnace slag and silica fume. The use of mineral additives in the cement is related to the fact that the use of the most expensive component of cement—Portland cement clinker—is limited. The purpose of the article is a preliminary evaluation of the suitability of slag from the municipal solid waste incineration plant for its use as a replacement of cement. In this article, slag from the municipal solid waste incineration (MSWI) replaces cement in the quantity of 30%, and presents the content of oxides and elements of slag from the MSWI. The obtained results are compared to the requirements that the crushed and granulated blast furnace slag need to meet to be suitable for use as an additive of type II to the concrete. The conducted analyses confirmed that the tested slag meets the requirements for the granulated blast furnace slag as an additive to the concrete in the following parameters: CaO ≤ 18.0%, SO3 ≤ 2.5% and Cl ≤ 0.1%. At the same time, mechanical features were tested of the designed mortars which consisted of a mixture of Portland cement (CEM I) with 30% of slag admixture. The designed mortar after 28 days of maturing reached a compressive strength of 32.0 MPa, and bending strength of 4.0 MPa. When compared to the milled granulated blast furnace slag (GBFS), the obtained values are slightly lower. Furthermore, the hardened mortars were subject to a leachability test to check the impact on the environment. Test results showed that the aqueous extracts from mixtures with 30% of slag admixtures slightly exceed the limits and do not pose a sufficiant threat to the environment as to eliminate the MSWI slag from economical use.

Highlights

  • In the past couple of years, we have observed a constant increase of the produced municipal waste

  • Test results indicated that the analyzed cement paste (Figures 5 and 6) containing 30% of blast furnace slag maintains complete volume following the requirements of standard EN 197-1:2002 [18]

  • It is indispensable to legally determine the requirements for the slags from municipal solid waste incineration (MSWI) plants so that they could be used as an additive to the mortar and in concrete

Read more

Summary

Introduction

In the past couple of years, we have observed a constant increase of the produced municipal waste. In 2018, 2.5 billion Mg of waste was generated in the EU countries. Municipal waste accounts for about 10% of their total stream. According to the data provided by Eurostat [1], in 2019, each inhabitant of Europe produced 489 kg of municipal wastes. Municipal wastes are considered as a global problem because they are very much visible and have very complex characteristics. Their amount and morphological content depend strongly on the civilization development, quality of life and society’s wealth. The form and weight of the produced municipal wastes are strongly

Objectives
Methods
Results
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call