Use of electrocautery devices for suture passage through the greater tuberosity: a biomechanical study.

Abstract

The use of electrocautery to facilitate passage of a suture needle through bone without the aid of a drill or burr is a novel technique that has potential utility in orthopedic procedures, but there is a scarcity of research to support its utility. The specific aims of this cadaveric biomechanical study were to evaluate (1) the axial force reduction during suture passage using electrocautery when applied to rotator cuff repair, (2) the temperature change caused while using electrocautery, and (3) the failure loads and failure modes of this technique. Five matched pairs of fresh frozen humeri were used, classified into 2 groups: with electrocautery on needle (study group) and without electrocautery on needle (control group). Four individual osseous tunnels were made on the greater tuberosity around the insertion of the supraspinatus tendon. Each specimen was sequentially tested in 2 parts: a needle penetration test (part I) to measure the peak axial force and temperature change and a single load-to-failure test (part II) to measure the maximum load to failure as well as the mechanism of failure. A No. 2 FiberWire suture with a straight needle was used. In part I, the mean peak axial force was lower in the study group compared with the control group for all osseous tunnels but was not statistically significant for individual tunnels. However, there was a significant decrease in peak axial force in the study group of 36% compared with the control group overall (P=.033). There was no significant change in temperature of the tunnel site with the use of electrocautery (mean: 0.2±0.3°C, P=.435). In part II, 100% of the samples from each study group experienced bone tunnel failure. Forty percent of the trials in the study group found lower ultimate failure loads compared with the control group (reduction range: 7%-38%). There was no statistically significant difference in the ultimate failure load between either the loop tested or between the 2 study groups (loop 1: P=.352; loop 2: P=.270). Suture passage using electrocautery does significantly decrease the peak force needed to pass a needle directly through the greater tuberosity. This technique does not appear to burn the bone or weaken the bone tunnels. This technique may be useful during open rotator cuff repair or shoulder arthroplasty, although clinicians should be cautious when using this technique as its utility depends on bone quality and cortical thickness, and invivo results may differ.