Use of DC voltage fluctuation method to investigate real-time Mode I and Mode II subcritical crack growth behavior in gypsum rock

Abstract

Subcritical crack growth strongly influences the mechanical behavior of rock and the precursory phase of geohazards and catastrophic failure. In earlier studies, indirect measuring methods were used to investigate the subcritical crack growth behavior of rock materials. However, these methods cannot fully reflect the whole process of subcritical crack growth of geomaterials. Therefore, in this study, a new method (DC voltage fluctuation method) was developed which can monitor the whole process of crack growth and measure the crack growth rate in real time. This method is based on the monitoring principle of change in voltage caused by the change in resistance. Then, the whole processes of Mode I and Mode II subcritical crack growth of gypsum specimen were monitored in real time by the self-designed fracture strain gauge, which consists of 10 breakable resistance wires, and a DC voltage signal monitor. Furthermore, using the measured crack growth rates and the stress intensity factors of varying crack path lengths, the parameters of the modified Charles model were fitted. The results show that: (1) the subcritical crack growth process mainly includes three stages: cracking latent period (primary stage), steady-state crack growth stage (secondary stage), and accelerated crack growth stage (tertiary stage). The cracking latent period lasts for the largest proportion of the entire fracture process duration. The duration of each stage decreases gradually with increasing applied load. (2) In the steady-state crack growth stage, both Mode I and Mode II crack growth rates increase with increasing applied load. However, the crack growth rates in the accelerated stage are basically the same with increasing applied load. When a specimen is subjected to a given constant applied load, the subcritical crack growth rate of Mode II is higher than that of Mode I in the secondary and tertiary stages. (3) The parameters A and n of the subcritical crack growth model (modified Charles model) (secondary stage) increase with increasing external applied load. The parameters are closely associated with the size of fracture process zone at the crack tip. The results of this study can provide a deeper insight into the macroscopic failure of rock, and also provide the parameters for the time-dependent damage evolutional process of underground constructions.