Abstract
Natural convection in a cubical porous container has been controlled by allowing the bottom wall to be of wavy shape and by inserting a conductive square cylinder inside of it. This control process has been investigated transiently in this paper using an alumina-water nanofluid by implementing a numerical method based on the Galerkin weighted residual finite element method. The Darcy-Forchheimer model has been adopted. Isothermal conditions are imposed at the bottom wavy wall (cold) as well as at the vertical walls (hot). Five parameters have been altered to assess the controlling problems. These are the Darcy number, porosity, volume fraction of the nanoparticles, dimension of the central body and the number of undulations of the bottom surface. The results show that the Darcy number exhibits a larger influence on both the Nusselt number and the average temperature than the other parameters, such that when Da is raised from 10−6 to 10−2 the increase in the Nusselt number is about 30.7 at ϕ=0.04, whereas the percentages of increase due to raising ϕ from 0 to 4% is about 11.7, 3.7 and 5.9 at Da=10−6,10−3 and 10−2, respectively. It is also noticed that the entropy generation within the container is mainly due to the thermal irreversibility at lower values of the Darcy number and porosity, and at higher number of undulations and volume fraction of nanoparticles.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.