Abstract
Modulating the crystal phase of a photocatalyst significantly impacts its surface and photochemical properties, allowing for the adjustment of catalytic activity and selectivity, particularly in the electrooxidation reactions of biomass-derived chemicals. Herein, monoclinic and hexagonal phases of WO3 are employed as photoanodes for the photoelectrochemical conversion of 5-hydroxymethylfurfural (HMF) to 2,5-diformylfuran (DFF). The monoclinic phase demonstrated exceptional performance in photoelectrocatalytic HMF oxidation, achieving remarkable photocurrent densities (1.1 mA cm-2), which were 5.5 times greater than those observed for hexagonal WO3. Moreover, the yield of DFF products obtained over monoclinic WO3 was approximately 2.5 times higher compared to that of hexagonal WO3. A combination of experiments and theoretical calculations indicates that the superior performance of monoclinic WO3 for HMF oxidation mainly originates from enhanced light harvesting efficiency, better charge separation and utilization, balanced adsorption energy, and stronger oxidative ability of photogenerated holes. This study emphasizes the potential of crystal phase engineering to regulate the reaction activity and selectivity and provides insights into how to design next-generation high-performance photoelectrodes for sustainable chemical production from biomass.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call