Abstract
In this study, submicron-WC reinforced Inconel 718 composites were fabricated by selective laser melting (SLM). They were investigated regarding forming quality, microstructure evolution, tensile and creep properties. The results demonstrated that SLM-processing with decreasing volumetric energy density (Ed), entailed the fabrication of composites with also decreasing density, due to the formation of more pores and cracks. The microstructure of the prepared composites mainly consisted of two different types, namely cellular and columnar dendrites, which formed within the molten pool. The microstructure was more heterogeneous at smaller length scale, whereby reduced grain size and enhanced high angle grain boundaries (HAGBs) were observed. At the optimal Ed of 120 J/mm3, the SLM-fabricated composite was highly dense and exhibited small stress concentration, so that it showed the highest microhardness (361.7 HV0.2), ultimate tensile strength (1030.5 MPa) and elongation (24.8%). Owing to elongated grain boundaries, which were characteristic for the respective microstructure, the composite displayed reduced creep life and ductility. The deformation behaviors during tension and creep were analyzed and they were interrelated to the microstructural defects, grain size, grain boundary morphology, and dislocation density.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
