Abstract
Large-scale undercoolings and long incubation periods for solidification of 63Sn-37Pb solder pastes were observed through a differential scanning calorimeter, as functions of cooling rate and contact surface (aluminium versus copper). The undercooling reduced significantly with decreased cooling rate, but even at a rate of 2°C/minute, the undercooling was as large as 35°C for a no-clean solder paste in an aluminium sample pan. Poor wetting conditions (weak flux, nonwetting surfaces) led to large undercoolings and long incubation periods. The undercooling during a typical reflow process in electronic assembly was determined, by a simulated DSC test, to be about 50°C for a no-clean solder paste on bare copper surface. The large undercooling is probably caused by the reduced degree of the heterogeneous nucleation for solidification due to the small size of a solder joint and poor wetting with its contact surface.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
