Uncertainty & sensitivity analyses for LOCA simulation of PHEBUS experiment FPT-1 using a modified SUNSET code

Abstract

Listen

Translate article

One task of the regulatory body during the review and assessment process is the quantification of uncertainty and sensitivity (U&S) during normal and accident conditions. Nowadays there are many codes having the capability of estimating U&S, but few of them can estimate uncertainty and sensitivity during severe accident conditions. The IRSN uncertainty propagation and sensitivity analysis tool named SUNSET is considered one of the most important tools used in U&S analysis, where it is coupled with ASTEC software package (Accident Source Term Evaluation Code) for computing U&S during severe accident condition. Unfortunately, the SUNSET tool cannot perform U&S analyses during all the transient time. The SUNSET software can only calculate U&S parameters for maximum, minimum, and last output values, therefore it was necessary to modify the SUNSET tool to calculate U&S during the whole transient time. The main objective of this study is to develop a Python script to replace the SUNSET post-processing step, extract the results, and perform U&S analysis. ASTEC code has been used for the simulation of a loss of coolant accident in the cold leg of the primary circuit of the FPT-1 test. The obtained results indicate the efficiency of the modified SUNSET tools to calculate the uncertainty during severe accidents. In general, it was found that the code is capable to model the main severe accident phenomena. SUNSET package shows good agreement with the experimental data, for the whole calculation period, until thermocouples failure moment. The obtained results show that the main safety parameters are very sensitive to the power multiplier.