Abstract
In this study, an ultrasonic irradiation technique was utilized to mitigate the fouling of polyethersulfone (PES) and polyvinylidene fluoride (PVDF) membranes. The use of ultrasound at 20 kHz was applied to a dead-end microfiltration cell in order to mitigate fouling caused by the presence of colloidal bentonite particles. The effect of ultrasonic power and pulse duration on the permeate flux recovery was examined. Measurements indicate that an increase in ultrasonic power and longer pulse duration results to a higher permeate flux recovery. In order to reduce power consumption, a low to high power shift (LHPS) and pulsation method, were investigated. Methods of cleaning such as ultrasonic irradiation, ultrasonic cleaning with forward flushing and ultrasonic cleaning with backwashing were utilized and their cleaning efficiencies were examined. The cleaning performance was assessed using the clean water flux method and scanning electron microscope analysis of the cleaned membranes. Results showed that LHPS and pulsation method both improve the permeate flux recovery but were not able to attain the 93.97 and 74.88% flux recovery for PES and PVDF that was achieved by constant-15 W ultrasonic cleaning. In addition, forward flushing and backwashing may enhance the performance of ultrasonic cleaning at 9 W but could become disadvantageous at 15 W.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.