Ultrasonic wave transmission and bandgap in multidirectional composite laminates with spring-type interlayer interfaces

Abstract

The ultrasonic wave transmission through multidirectional composite laminates is studied theoretically by accounting for the effect of thin interlayer resin-rich regions based on the spring-type interface model. Using the stiffness-matrix method, the energy transmission spectrum of the longitudinal wave impinging obliquely on cross-ply and quasi-isotropic laminates immersed in water is calculated. The location and bandwidth of the frequency ranges where the transmissivity becomes vanishingly small are shown to be significantly influenced by the incident angle, the laminate lay-up, and the interlayer interfacial stiffnesses. By examining the energy flux density of partial waves inside the laminate, these frequency ranges are shown to be the bandgaps due to the constructive interference of scattered waves from the interlayer interfaces. The mode combination causing the interference is found to vary remarkably with the bandgap location. Furthermore, the interference in the finite laminate structure is shown to occur in almost the same manner as the Floquet wave does in the infinitely extended laminate structure. The energy transmission spectrum is experimentally measured for 16-ply carbon/epoxy cross-ply and quasi-isotropic composite laminates using the through-transmission technique. The transmission and bandgap characteristics observed in the experimental results are reasonably reproduced by the present theory incorporating the interlayer resin-rich regions.