Ultrasonic Joining of Additively Manufactured Metal-Composite Hybrid Joints: A Comparison between Vertical and Horizontal Vibration Modes

Abstract

Ultrasonic Joining (U-Joining) is a novel friction-based joining technique that produces through-the-thickness reinforced hybrid joints between surface-structured metals and thermoplastics. The process feasibility has been successfully demonstrated to join metals and unreinforced or fiber-reinforced polymer parts by applying horizontal vibration. However, intense tool wear was observed for the explored combinations of materials, which could diminish the mechanical performance of the produced joints and hinder the process application. These investigations left an unexplored field regarding the application of different vibration modes, which could represent good solutions to minimize the intense tool wear reported. Therefore, the present study aims to explore the application of vertical vibration and to identify possible advantages and disadvantages of this variation. The case-study combination of additively manufactured 316L stainless steel and 20%-short-carbon-fiber reinforced poly-ether-ether-ketone was selected for this purpose. Initially, a set of optimized joining parameters was obtained for the vertical variation following a one-factor-at-a-time approach. In a previous study, the joining parameters were already optimized for the horizontal mode, and the results were used for comparison purposes. Single-lap shear joints were produced using both optimized modes, and the process monitoring indicated that joints produced using vertical vibration reached a lower joining energy input for a given joining time. The produced joints were tested, and joints produced with the horizontal variation achieved higher ultimate lap shear forces than the ones achieved by the vertical ones: 3.6 ± 0.3 kN and 1.6 ± 0.3 kN, respectively. Microstructural investigations at the fractured surfaces showed that this difference is due to insufficient frictional heat generation at the metal-composite interface when vertical vibration is applied. Therefore, the temperatures reached during the joining cycle are not enough to melt the polymer completely at the interface, preventing a complete surface wetting of the metal and reducing the micromechanical interlocking and adhesion bond between the parts, thereby diminishing the mechanical performance of the produced joints.