Abstract
We report on the characterization and long-term compensation of additive timing jitter introduced by a femtosecond ytterbium regenerative amplifier with a 100 kHz repetition rate. A balanced optical cross-correlation technique is used to generate a jitter error signal. This approach is well suited to characterize the additive timing jitter of Yb amplifiers seeded by narrow spectrum Yb oscillators. The balanced optical cross-correlator is in a noncollinear configuration allowing a background free coindence detection. This setup enables the measurement of additive timing jitter from the amplifier, with a noise floor of 300 as integrated from 10 Hz to 10 kHz. The measured additive timing jitter level is about 5 fs, integrated from 0.1 Hz to 10 kHz. The amplifier timing drift characterization and control are performed for more than an hour.
Submitted Version (
Free)
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call