Abstract
A two-axis-of-rotation drive system has been developed that enables electron-beam lithography (EBL) to be applied to three-dimensional (3D) nanofabrication. It is built on a pallet that can be loaded into the EBL apparatus, and rotates a sample while the e-beam writes on it. It has a positional accuracy of a few milliradians. In addition, a height-measurement system has also been developed. This helps to focus the e-beam on the surface of a rotating or non-planar sample, and enables fine patterns to be formed on such samples. These systems allow samples to be exposed to the e-beam from various directions, resulting in 3D fabrication with a high degree of freedom. A demonstration carried out on a polymethylmethacrylate sphere resulted in the formation of pillars with various shapes and about 100 nm in diameter.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
