Two-phase flow phenomena along an adiabatic riser – An experimental study at the test-facility GENEVA

Abstract

Long adiabatic riser geometries with low system pressures are present in a lot of energy and petrochemical processes. Natural-circulation systems are an appropriate solution to save operating and maintenance costs. Under certain circumstances natural-circulation systems tend to unstable mass flow, especially in the riser section. The pressure gradients can stress the construction materials and affect the heat transfer. This paper focuses on GENEVA test-facility and its natural-circulation circuit with heat input by steam condensation. The GENEVA test-facility is explained in detail with focus on the local void fraction measurement system in the adiabatic riser section. The differences to former natural circulation test-facilities are particular emphasized. Therefore a transient experiment is presented and analysed. Moreover the influence of flow restrictions at the downcomer outlet is explained and an experimental method is presented, to determine the maximum natural circulation mass flow of the natural-circulation circuit. Besides, a comparison between the two different riser inner diameters, which were used during the experiments, is presented. The convective heat transfer is analysed by taking into account different dimensionless numbers. A variety of experiments were performed up to 100kWel input power from the evaporators. Flashing and geysering as two types of occurred instabilities are stated and discussed in comparison to former test-facilities. Further phenomena like water hammer and counter current liquid flow are investigated. Based on these analyses constructive solutions can be derived, to stabilize the presented natural-circulation two-phase flow system.