Abstract
We have experimentally investigated two-dimensional imaging of stepped Si surfaces by energy-analyzed electrons and Auger electron spectra from atomically flat surfaces. A stepped Si(111) surface was prepared by direct-current heating to around 1250 °C in ultrahigh vacuum. The stepped surface consisted of atomically flat terraces and step bands where atomic steps bunched in the height of about 5 nm. We found that the stepped structure could be imaged by using only the energy-analyzed secondary electrons (SEs) when the intensity was defined as the difference between the peak height and the background intensity. The image from the energy-analyzed SEs was in good agreement with the conventional SEM image obtained with non-energy-analyzed SEs. The electron-emission spectrum obtained in the direct mode included only characteristic Auger peaks of silicon SE peak. It is found that the electron-emission spectrum obtained from the atomically flat Si(111) terrace has relatively higher background than that from a sputter-cleaned Si surface. Also, it is revealed that the fine structure exists at 2.2 eV in the SE peak.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Journal of Vacuum Science & Technology A: Vacuum, Surfaces, and Films
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.