Tribological Performance of Halogen-Free Ionic Liquids in Steel–Steel and DLC–DLC Contacts

Abstract

ABSTRACTThe tribological performance of halogen-free ionic liquids at steel–steel and diamond-like carbon (DLC)–DLC contacts was investigated. Hydrogenated amorphous carbon (a-C:H) and tetrahedral amorphous carbon (ta-C) were used as test specimens. Friction tests were carried out on steel–steel, a-C:H–a-C:H, and ta-C–ta-C contacts by using a reciprocating cylinder-on-disk tribotester lubricated with two different types of halogen-free ionic liquids: 1-ethyl-3-methylimidazolium dicyanamide ([BMIM][DCN]) and 1-butyl-3-methylimidazolium tricyanomethanide ([BMIM][TCC]). From the results of friction tests, the ta-C–ta-C tribopair lubricated with [BMIM][DCN] or [BMIM][TCC] exhibited an ultralow friction coefficient of 0.018–0.03. On the other hand, ultralow friction was not observed at the steel–steel and a-C:H–a-C:H contacts. Measurements obtained with a laser scanning microscope and an atomic force microscope (AFM) showed that a chemical reaction film, derived from the ionic liquid lubricant used, was formed on the steel surfaces. However, this chemical reaction film was not observed on either of the DLC surfaces. The AFM results showed that there were high-viscosity products on the ta-C surfaces, that the wear tracks on the ta-C surfaces exhibited low frictional properties, and that the ta-C surfaces were extremely smooth after the friction tests. Based on these results, it was concluded that an ionic liquid–derived adsorbed film formed on the ta-C surface and resulted in the ultralow friction when lubricated with a halogen-free ionic liquid.