Trends in Total Knee Arthroplasty Cementing Technique Among Arthroplasty Surgeons—A Survey of the American Association of Hip and Knee Surgeons Members

Abstract

BackgroundAseptic loosening persists as one of the leading causes of failure following cemented primary total knee arthroplasty (TKA). Cement technique may impact implant fixation. We hypothesized that there is variability in TKA cement technique among arthroplasty surgeons. MethodsA 28-question survey regarding variables in surgeons’ preferred TKA cementation technique was distributed to 2,791 current American Association of Hip and Knee Surgeons (AAHKS) members with a response rate of 30.8% (903 respondents). Patterns of responses were analyzed by grouping respondents by their answers to certain questions including cementing technique, tibial cement location, and femoral cement location. ResultsA total of 73.5% reported performing at least 7 of 8 of the highest consensus techniques, including vacuum mixing (79.9%), using two bags (76.1%), tibial implant first (95.2%), single-stage cementing (96.9%), compression of the implants in extension (91.7%), and use of a tourniquet (84.3%). Medium and high viscosity cement was most commonly used (37.9 and 37.8%, respectively). Finger pressurization was most common (76.1%) compared to a gun (29.8%). There were 26.5% of respondents performing 6 or fewer of the most common majority techniques and seemed to perform other less common techniques (eg, use of a single bag of cement, trialing or closure prior to cement curing, and heating to accelerate cement curing). Cement was most commonly applied to the entire bone and implant surface on both the tibia (46.4%) and femur (47.7%), leaving much variation in the remaining cement application location responses. DiscussionThere appears to be variability in cemented TKA technique among arthroplasty surgeons. There were 26.5% of respondents performing less of the majority techniques and also performed other additional low-response rate techniques. Further studies that look at the impacts of variation in techniques on outcomes may be warranted. Our study demonstrates the need for defining best practices for cement technique given the substantial variability identified.