Transformation kinetics of polycrystalline aragonite to calcite: new experimental data, modelling, and implications

Abstract

Experimental data are used to model the transformation rate of polycrystalline aragonite (grain diameter ∼80 μm) to calcite. Optimized values for nucleation and growth rates were obtained by numerically fitting the overall transformation rates from 280° to 380°C and 0.10 MPa to an expression for a grain-boundary-nucleated and interface-controlled transformation. The nucleation rate is ∼4–5 orders of magnitude faster than for calcite nucleated within aragonite grains, and the growing in rate is slower below 300°C than for calcite growing in aragonite single crystals. The activation enthalpy for growth in polycrystalline aggregate is ∼247kJ/mol compared to 163 kJ/mol for growth in single crystals. Permanent deformation of the phases limits the elastic strain energy due to the ∼7% volume change and reduces the coherency of the calcite/aragonite interace. Theoretical expressions are used to extrapolate the data for nucleation and growth to other temperatures, and data from 0.10 to 400 MPa are used to evaluate the effect of pressure on the grain-boundary nucleation rate. Because of permanent deformation of the phases, the effective strain energy for nucleation is ≤0.55 kJ/mol, which is less than a quarter of the value for purely elastic deformation. These data are used to predict the percent transformation for various P-T-t paths; without heating during uplift partial preservation of aragonite in dry blueschist facies rocks can occur if the calcite stability field is entered at ∼235° C, and the kinetic data are also consistent with published P-T-t paths which include heating during uplift. The predicted percent transformation is relatively insensitive to variations in the initial grain size of the aragonite, but strongly dependent on the effective strain energy.