Topographic analysis of fiber posts after surface disinfection with different methods

Abstract

Aims: This study aims to comprehensively examine the surface morphology of fiber posts after undergoing various disinfection methods, utilizing scanning electron microscopy (SEM) and energy dispersive X-ray spectroscopy (EDX). Materials and Methods: Twenty-one fiber posts were randomly allocated into seven experimental groups, each consisting of three samples. The disinfection methods employed were as follows: GC - no disinfection treatment; GAL - immersion in 70% alcohol, following the manufacturer's recommended protocol; GHP - soaking in 2.5% sodium hypochlorite for a duration of 10 minutes; GCL - soaking in 2% chlorhexidine gluconate for a period of five minutes; GAC - 30-second etching with 35% phosphoric acid; GPH - soaking in 10% hydrogen peroxide for a duration of 20 minutes; and GSL - autoclave sterilization. Following the disinfection procedures, SEM was employed to scrutinize the surface topography of the posts, while EDX was utilized to identify the chemical elements present on the sample surfaces. Subsequently, a descriptive analysis was conducted on the SEM images and EDX data. Results: SEM analysis revealed that all groups exhibited regions with epoxy resin-coated fibers alongside sections with exposed glass fibers. Analysis of the EDX data indicated that there were no significant differences in the predominant chemical elements across the groups. Carbon (C) and oxygen (O) registered the highest peaks, followed by silicon (Si), zirconium (Zr), sodium (Na), aluminum (Al), and calcium (Ca). Conclusions: The disinfection methods under investigation did not induce substantial alterations in the surface morphology of the fiber posts.