Tight integration of real-time GNSS PPP and INS: Ionosphere-free combined vs uncombined models

Abstract

The GNSS Precise Point Positioning (PPP) model is usually established in either an ionospheric-free (IF) combined form or an uncombined (UC) form. These formulations can be equivalent in theory but their applications in practice could still perform differently when integrated with external sensors. In this study, we compared the positioning performance of the two PPP models tightly coupled with the Inertial Navigation System (INS) using a high-grade inertial measurement unit (IMU) in real vehicle navigation tests. The ambiguity resolution (AR) was also exploited in the two PPP models after applying the observable specific biases (OSB) to the GNSS raw code and phase measurements. According to the results, under good satellite observability the UC PPP/INS tightly-coupled integration (TCI) significantly outperforms the IF PPP/INS TCI. The UC TCI model with AR could achieve a positioning accuracy of 4.6 and 3.0 cm in the horizontal and vertical directions, which are improved by 37 % and 63 % respectively relative to the IF TCI model. However, in the case of frequent GNSS signal interruptions or poor satellite observation condition, the IF TCI model shows a superior reliability than the UC TCI. Nevertheless, when the ionospheric parameters are properly constrained in the UC TCI model, substantial improvements in terms of convergence and accuracy are obtained. The UC PPP augmented with external precise ionospheric information would greatly increase the cost, and users may select the appropriate PPP model with INS TCI in real applications in accordance with the demanded accuracy level and measuring conditions.