Abstract
AbstractA three‐dimensional simulation code with the finite difference time domain (FDTD) method combined with the electron fluid model has been developed for the microwave excited surface wave plasma in the RDL‐SWP device. This code permits the three‐dimensional numerical analysis of the spatial distributions of electric field, power absorption, electron density, and electron temperature. At a low gas pressure (about 10 mTorr), the numerical results were compared with the experimental measurements that show the validity of this 3D simulation code. A simplified analysis assuming that the electron density is spatially uniform has also been studied and its applicability is evaluated by the comparison of the 3D simulation and the analytical solutions. The surface wave eigenmodes are determined by the electron density, and it is found that the structure of the device strongly influences the spatial distribution of the electric fields of surface waves in a low‐density area (ne < 3.0 × 1011 cm−3). A method to irradiate by microwave the whole surface area of the plasma is proposed. The method is found to be effective in obtaining a high uniformity distribution of electron density. © 2005 Wiley Periodicals, Inc. Electr Eng Jpn, 150(4): 1–12, 2005; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/eej.10333
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.