Three-dimensional stress distribution around cold expanded holes in aluminium alloys

Abstract

Aluminium alloy 6082 (HE30) and aluminium-lithium alloys 8090 and 2091 were examined after holes were cut and cold-expanded by means of an oversized mandrel. The extent of cold working was analysed by two techniques, namely neutron diffraction (ND) and the Sachs cutting method (SM). While the former requires neutron diffraction facilities and is a non-destructive measurement technique, the latter is based on the removal of small layers of material from the inside of the expanded hole while recording the apparent change in strain by the removal of the layer. The stress distributions analysed by ND are compared with the method of Sachs and the results are discussed with respect to distances over which the state of stress changes from compression to tension. These changes are significant in explaining the improvement of service life in mechanical fastener holes from the process of cold expansion. In all alloys examined it was found that the improved fatigue performance was a function of the degree of expansion. All alloys exhibited a maximum in expansion beyond which fatigue life deteriorated. This was due to crack initiation during excessive hole enlargement exceeding the yield strength of the alloys. Crack initiation usually started from inside the hole of the fastener but always perpendicular to the applied load. The initial stages of growth occurred perpendicularly over a short distance but further growth occurred on a plane with normals inclined at about 55–60° to the tensile axis. This behaviour was due to the presence of texture development in the alloys which is beneficial to the resistance of both fatigue crack initiation and propagation.