Abstract

The three-dimensional microstructures of a conventional 316L stainless steel and the same material after grain boundary (GB) engineering have been measured by serial sectioning coupled with electron backscatter diffraction mapping. While it is well known that GB engineered materials are differentiated from conventional materials because of the proportion of coincidence site lattice boundaries, the size of their twin-related domains, and their reduced random boundary connectivity, this work provides a quantitative comparison of the geometrical and topological characteristics of grains in 316L stainless steel before and after GB engineering. Specifically, the numbers of grain faces, triple lines, and quadruple unions per grain have been measured and compared. In addition, the distributions of grain sizes, surface areas, and grain boundary areas have been measured and compared. The results show that, in many ways, the three-dimensional geometrical and topological characteristics of the grains in the GB engineered and conventional materials are similar. In both materials, the distributions of the geometrical parameters are well represented by a log-normal distribution. Comparatively, the GB engineered microstructure has grains that, on average, have both fewer faces and higher (specific) surface areas that deviate more from an ideal equiaxed shape, but there are several eccentric or non-compact shaped grains that have a huge number of faces and extremely large surface area in the GB engineered material. All of these characteristics are likely to be a result of the increased number of twins in the GB engineered microstructure. These eccentric grains would have a positive influence on increasing the resistance to intergranular degradation.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call