Thermoresponsive Surfaces Grafted by Shrinkable Hydrogel Poly(N-isopropylacrylamide) for Controlling Microalgae Cells Adhesion during Biofilm Cultivation.

Abstract

Listen

Translate article

Microalgae is a promising candidate for reducing greenhouse gas and producing renewable biofuels. For microalgae biofilm cultivation, a strong adhesion ability of microalgae cells onto the surface is a prerequisite to resist the fluid shear stress, while strong adhesion is not of benefit to the biofilm harvesting process. To solve this dilemma, a thermoresponsive surface (TMRS) with lower critical solution temperature of 33 °C was made by grafting N-isopropylacrylamide onto a silicate glass slide. The wettability of the TMRS changed from hydrophilic (contact angle of 59.4°) to hydrophobic (contact angle of 91.6°) when the temperature rose from 15 to 35 °C, resulting in the increase of adhesion energy of the TMRS to Chlorella vulgaris cells by 135.6%. The experiments showed that the cells were more likely to attach onto the TMRS at the higher temperature of 35 °C owing to the surface microstructures generated by the hydrogel layer shrinkage, which is similar in size to the microalgae cells. And the cell coverage rate on TMRS increased by 32% compared to the original glass surface. Conversely, the cells separate easily from the TMRS at a lower temperature of 15 °C, and the cell adhesion density was reduced by 19% due to hydrogel layer swelling to a relatively flat surface.