Abstract
Casting experiments were conducted to characterise hot tearing in two aluminium alloys (A356 and M206) using an instrumented constrained permanent mould. The thermal history, thermal contraction and the tensile force induced by thermal contraction were monitored during the casting process. The thermal stress was modelled by considering the contact between the solidified metal and the mould. The calculated displacement and tensile load were compared to measured data and reasonably good agreement was observed. Hot tearing tendency of these two aluminium alloys was predicted using a strain based hot tearing model. It was found that M206 not only demonstrated much higher hot tearing tendency than A356, but also the vulnerable locations for hot tearing were different from A356. The predicted hot tearing positions coincide well with those observed in the castings. The effects of mould temperature, mould material and pouring temperature on the susceptibility of hot tearing were also investigated.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
