Thermoelectrical Generator for a MEMS-Fuze

Abstract

The structure of modern fuzes includes micro-electromechanical systems (MEMS), which have such advanced devices as micro-accelerometers and micro-switches, being triggered at a specified level of setback. Independent power source (PS), as an inherent part of the MEMSfuze, charges an energy storage unit during the shot and triggers the fuze firing circuit when the shell encounters the target. Operating level of the control signal should be achieved within the time of remote arming, determined by the type of ammunition. The paper considers a possibility to develop PS as a thermoelectric generator (TEG) with aerodynamic heating of hot junctions due to friction of the projectile body on the incoming airflow. The initial temperature is determined by the driving band cutting into the rifling and friction during the movement of projectile through the tube bore. The paper presents a technique for calculating the temperature field along the body of the projectile from the critical point, located at the top of the shell head. The solution of the equation of heat balance reveals the temporal development of the projectile body temperature. The proposed mathematical model of the TEG describes the process of converting heat into electrical output signal (thermo-EMF). An example of calculation for a specific artillery system – 57-mm anti-aircraft gun S-60 is given. Calculation of the TEG output signal was limited by the time, which is necessary to reach the top of the projectile trajectory. It is shown that at high altitude the temperature difference may drop to zero, thus cutting off the TEG output signal. Selection of capacitive storage parameters can be based on the reliability test conditions of the fuze firing circuit actuators, taking into account the partial storage discharge on the trajectory before the projectile encounters the target.