Thermodynamic and thermoeconomic analyses of a trigeneration (TRIGEN) system with a gas–diesel engine: Part II – An application

Abstract

The paper is Part 2 of the study on the thermodynamic and thermoeconomic analyses of trigeneration system with a gas–diesel engine. In Part 1, thermodynamic and thermoeconomic methodologies for such a comprehensive analysis were provided, while this paper applies the developed methodology to an actual TRIGEN system with a rated output of 6.5 MW gas–diesel engine installed in the Eskisehir Industry Estate Zone, Turkey. Energy and exergy efficiencies, equivalent electrical efficiency, the Public Utility Regulatory Policies Act (PURPA) efficiency, fuel energy saving ratio, fuel exergy saving ratio and other thermodynamic performance parameters are determined for the TRIGEN system. The efficiencies of energy, exergy, PURPA and equivalent electrical efficiency of the entire system are found to be 58.97%, 36.13%, 45.7% and 48.53%, respectively. For the whole system and its components, exergetic cost allocations and various exergoeconomic performance parameters are calculated using the exergoeconomic analysis based on specific exergy costing method (SPECO). The specific unit exergetic cost of the net electrical power, heat energy in the Factory Heating Center (FHC) heating, heat energy in the Painting Factory Heating (PFH) and chilled water in the absorption chiller (ACh) produced by the TRIGEN system are obtained to be 45.94 US$/GJ, 29.98 US$/GJ, 42.42 US$/GJ and 167.52 US$/GJ, respectively.