Thermal performance of concrete bricks based phase change material encapsulated by various aluminium containers: An experimental study under Iraqi hot climate conditions

Abstract

This study presents the experimental results of concrete bricks based macroencapsulated phase change material (PCM) in different capsule designs (circular, square and rectangular cross-sections). Eight concrete bricks (including a reference brick without PCM) are fabricated, and their thermal performance is tested under hot summer conditions of Al Amarah city, Iraq. The study considered several indicators such as the interior maximum temperature reduction (MTR), decrement factor (DF) and time lag (TL) to compared among tested bricks in addition to the thermal behaviour during melting and solidification of PCM. Results indicated that all PCM based bricks are performed better than the reference brick in which the maximum interior temperature is shaved and shifted. Moreover, the best thermal performance is reported for bricks of large PCM capsules number. Amongst others, the brick-based square cross-section PCM capsules showed the best thermal contribution where the average MTR of 1.88°C, average DF of 0.901 and average TL of 42.5 min were obtained compared with the reference brick. The study concluded that PCM capsules' heat transfer area is the main parameter that controls PCM's thermal behaviour as long as all PCM capsules have the same PCM quantity and position. Therefore, excessive encapsulation area might influence the thermal performance of concrete brick and should be specified for the efficient use of PCM storage capacity.